HPE FlexFabric 5940 SERIES Fundamentals Command Reference

68
Usage guidelines
If the HTTP service and HTTPS service are enabled, changes to the applied SSL server policy do not
take effect. For the changes to take effect, you must disable HTTP and HTTPS, and then apply the
policy and enable HTTP and HTTPS again.
To restore the default, you must disable HTTP and HTTPS, execute the undo ip https
ssl-server-policy command, and then enable HTTP and HTTPS again.
Examples
# Apply SSL server policy myssl to the HTTPS service.
<Sysname> system-view
[Sysname] ip https ssl-server-policy myssl
Related commands
ssl server-policy (Security Command Reference)
line
Use line to enter one or multiple user line views.
Syntax
line { first-number1 [ last-number1 ] | { aux | vty } first-number2 [ last-number2 ] }
Views
System view
Predefined user roles
network-admin
Parameters
first-number1: Specifies the absolute number of the first user line. The value range is 0 to 73.
last-number1: Specifies the absolute number of the last user line. The value range is 1 to 73. This
number cannot be smaller than first-number1.
aux: Specifies the AUX line.
vty: Specifies the VTY line.
first-number2: Specifies the relative number of the first user line. The value range is 0 to 9 for AUX
lines and 0 to 63 for VTY lines.
last-number2: Specifies the relative number of the last user line. The value range is 1 to 9 for AUX
lines and 1 to 63 for VTY lines. This number cannot be smaller than first-number2.
Examples
# Enter the view of VTY line 0.
<Sysname> system-view
[Sysname] line vty 0
[Sysname-line-vty0]
# Enter the views of VTY lines 0 to 63.
<Sysname> system-view
[Sysname] line vty 0 63
[Sysname-line-vty0-63]
Related commands
line class

HPE FlexFabric 5940 SERIES Specifications

General

Brand	HPE
Model	FlexFabric 5940 SERIES
Category	Switch
Language	English