82
source: Specifies a source IPv4 address or source interface for outgoing Telnet packets. If you do
not specify this option, the device uses the primary IPv4 address of the output interface for the route
to the server as the source address.
interface interface-type interface-number: Specifies the source interface. The primary IPv4 address
of the interface will be used as the source IPv4 address for outgoing Telnet packets.
ip ip-address: Specifies the source IPv4 address for outgoing Telnet packets.
dscp dscp-value: Specifies a DSCP value for outgoing Telnet packets. The value range is 0 to 63.
The default is 48.
Usage guidelines
This command is not supported in FIPS mode.
To terminate the current Telnet connection, press Ctrl+K or execute the quit command.
The source address or interface specified by this command is applied only to the Telnet connection
that is being established.
Examples
# Telnet to host 1.1.1.2, using 1.1.1.1 as the source IP address for outgoing Telnet packets.
<Sysname> telnet 1.1.1.2 source ip 1.1.1.1
Related commands
telnet client source
telnet client source
Use telnet client source to specify a source IPv4 address or source interface for the Telnet client to
use for outgoing Telnet packets.
Use undo telnet client source to restore the default.
Syntax
telnet client source { interface interface-type interface-number | ip ip-address }
undo telnet client source
Default
No source IPv4 address or source interface is specified. The Telnet client uses the primary IPv4
address of the output interface for the route to the server as the source IPv4 address.
Views
System view
Predefined user roles
network-admin
Parameters
interface interface-type interface-number: Specifies a source interface. The primary IPv4 address of
the interface will be used as the source IPv4 address for outgoing Telnet packets.
ip ip-address: Specifies a source IPv4 address.
Usage guidelines
This command is not supported in FIPS mode.
The setting configured by this command applies to all Telnet connections but has a lower
precedence than the source setting specified for the telnet command.
To Next Page
Loading...
Need help?
General