241
display transceiver diagnosis
Use display transceiver diagnosis to display the current values of the digital diagnosis parameters
on transceiver modules.
Syntax
display transceiver diagnosis interface [ interface-type interface-number ]
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
interface [ interface-type interface-number ]: Specifies an interface by its type and number. If no
interface is specified, this command displays the current values of the digital diagnosis parameters
on every transceiver module.
Examples
# Display the current values of the digital diagnosis parameters on the transceiver module in
interface Ten-GigabitEthernet 1/0/1.
<Sysname> display transceiver diagnosis interface ten-gigabitethernet 1/0/1
Ten-GigabitEthernet1/0/1 transceiver diagnostic information:
Current diagnostic parameters:
Temp(°C) Voltage(V) Bias(mA) RX power(dBm) TX power(dBm)
36 3.31 6.13 -35.64 -5.19
Alarm thresholds:
Temp(°C) Voltage(V) Bias(mA) RX power(dBM) TX power(dBM)
High 50 3.55 1.44 -10.00 5.00
Low 30 3.01 1.01 -30.00 0.00
Table 45 Command output
Field Description
transceiver diagnostic information Digital diagnosis information for the transceiver module in the interface.
Temp.(°C) Temperature in °C, accurate to 1°C.
Voltage(V) Voltage in V, accurate to 0.01 V.
Bias(mA) Bias current in mA, accurate to 0.01 mA.
RX power(dBm) Receive power in dBm, accurate to 0.01 dBm.
TX power(dBm) Transmit power in dBm, accurate to 0.01 dBm.
display transceiver interface
Use display transceiver interface to display the key parameters of transceiver modules.
Syntax
display transceiver interface [ interface-type interface-number ]
To Next Page
Loading...
Need help?
General