270
Preprovisioning commands
display provision failed-config
Use display provision failed-config to display preprovisioned-commands application failure
records.
Syntax
display provision failed-config
Views
Any view
Predefined user roles
network-admin
network-operator
Usage guidelines
A preprovisioned command cannot be applied if it conflicts with the running configuration.
Use this command to verify the application result of preprovisioned commands except for the
following commands:
• duplex
• speed
• sflow
To verify the application result of the listed commands, use the display current-configuration
command. The display provision failed-config command might display incorrect application
results for the listed commands.
Examples
# Display preprovisioned-commands application failure records.
<Sysname> display provision failed-config
Configuration applied at: Sat Jun 14 06:06:00 2014
Slot information: slot 1
Commands that failed to be applied:
#
interface Ten-GigabitEthernet1/0/1
speed 10000
#
Related commands
provision
reset provision failed-config
provision
Use provision to enable preprovisioning.
Use undo provision to disable preprovisioning.
To Next Page
Loading...
Need help?
General