178
Loading......................Done.
Loading......................Done.
Loading......................Done.
Loading......................Done.
The images that have passed all examinations will be used as the main startup software
images at the next reboot on slot 2.
The images that have passed all examinations will be used as the main startup software
images at the next reboot on slot 3.
Decompression completed.
Do you want to delete flash:/all.ipe now? [Y/N]:n
Related commands
display boot-loader
boot-loader update
Use boot-loader update to synchronize startup images.
Syntax
boot-loader update { all | slot slot-number }
Views
User view
Predefined user roles
network-admin
Parameters
all: Synchronizes startup images from the master to all subordinate devices.
slot slot-number: Specifies the IRF member ID of a subordinate device.
Usage guidelines
You can use this command to synchronize startup images after adding new member devices.
The startup images synchronized to the subordinate device are set as main startup images,
regardless of whether the source startup images are main or backup.
• If the master device has started up with main startup images, its main startup images are
synchronized to the subordinate device, regardless of whether any main startup image has
been respecified on the master device.
• If the master device has started up with backup startup images, its backup startup images are
synchronized to the subordinate device, regardless of whether any backup startup image has
been respecified on the master device.
If an ISSU patch installation or software upgrade has been performed, use the install commit
command to update the set of main startup images on the master before software synchronization.
This command ensures startup image consistency between the master and the subordinate device.
Startup image synchronization fails if any software image being synchronized is not available or is
corrupted.
Examples
# Synchronize startup images from the master device to the subordinate device in slot 1.
<Sysname> boot-loader update slot 1
This command will update the specified standby MPU. Continue? [Y/N]:y
Updating. Please wait...
To Next Page
Loading...
Need help?
General