11
Predefined user roles
network-admin
Parameters
number: Specifies the number of the most recently executed commands in the command history
buffer for the current CLI session that you want to execute. The value range is 1 to 10. The default is
1.
count times: Specifies the number of times that you want to execute the commands. The value
range is 0 to 4294967295. The default is 0. If you do not specify this option, the system keeps
executing the commands until you press the escape key to terminate the execution.
delay seconds: Specifies the time (in seconds) for the system to wait before executing the
commands again. The value range is 0 to 4294967295. The default is 1.
Usage guidelines
To repeat a command, first enter the view for the command. To repeat multiple commands, first enter
the view for the first command.
The repeat command executes commands in the order they were executed.
The system waits for your interaction when it repeats an interactive command.
Examples
# Configure the system to execute the two most recently executed commands (display cpu and
display clock) three times at an interval of 10 seconds.
<Sysname> repeat 2 count 3 delay 10
<Sysname> display cpu
Slot 1 CPU 0 CPU usage:
33% in last 5 seconds
32% in last 1 minute
33% in last 5 minutes
<Sysname> display clock
12:20:08 UTC Thu 06/19/2014
<Sysname> display cpu
Slot 1 CPU 0 CPU usage:
33% in last 5 seconds
32% in last 1 minute
33% in last 5 minutes
<Sysname> display clock
12:20:18 UTC Thu 06/19/2014
<Sysname> display cpu
Slot 1 CPU 0 CPU usage:
33% in last 5 seconds
32% in last 1 minute
33% in last 5 minutes
<Sysname> display clock
12:20:28 UTC Thu 06/19/2014
Related commands
display history-command
escape-key
history-command max-size
To Next Page
Loading...
Need help?
General