Keysight Technologies InfiniiVision DSOX1204A User Manual

Index
Keysight InfiniiVision DSOX1204A/G Oscilloscopes Programmer's Guide 943
rising pulse count measurement, 373
RMS value measurement, 392
roll time base mode, 575
root (:) commands, 133, 135
root level commands, 3
root path for USB storage devices, 571
RQL (Request Control) status bit, 113, 115
RQS (Request Service), 128
RS-232/UART triggering, 462
RST (Reset), 121
rules, tree traversal, 803
rules, truncation, 800
run, 129, 159
Run bit, 150, 152
run mode, mask test, 418
running configuration, 124, 567
Rx frame count (UART), 530
Rx source, 535
S
sample rate, 3, 188
sampled data, 720
sampled data points, 642
SAV (Save), 124
save, 124, 442
SAVE commands, 441
save filename, 444
save image, 445
save image with inksaver, 448
save mask, 450
save mask test failures, 421
save path information, 452
save reference waveform, 460
save setup, 453
save to reference waveform location, 706
save waveform data, 454
saved image, area, 754
saving and recalling data, 228
SBUS CAN commands, 466
SBUS commands, 461
SBUS<n> commands, general, 463
scale, 266, 307, 579, 583
scale factors output on hardcopy, 315, 446
scale for channels, 219
scale units for channels, 220
scale units for external trigger, 258
scaling display factors, 212
SCPI.NET examples, 933
scratch measurements, 732
screen area for hardcopy print, 313
screen area for saved image, 754
screen display of logged remote commands,
enable/disable, 562
screen image data, 234
SECAM, 628, 632
seconds per division, 579
segmented waveform save option, 458
segments, analyze, 183
segments, count of waveform, 652
segments, setting number of memory, 184
segments, setting the index, 185
segments, time tag, 653
select measurement channel, 380
self-test,
130
sensing a channel probe, 719
sensing a external trigger probe, 722
sensitivity of oscilloscope input, 212
sequential commands, 806
serial clock, 485, 513
serial data, 486
serial decode bus, 461
serial decode bus display, 464
serial decode mode, 465
serial frame, 514
serial number, 160
service request, 128
Service Request Enable Register
(SRE), 126, 772
set center frequency, 261, 293
set cursors, 737, 738
set date, 548
set time, 569
set up oscilloscope, 33
setting display, 292
setting external trigger level, 249
setting impedance for channels, 208
setting inversion for channels, 209
settings, 120, 124
settings, instrument, 312
setup, 178, 203, 228, 312, 567
setup and hold trigger clock source, 618
setup and hold trigger data source, 619
setup and hold trigger hold time, 620
setup and hold trigger setup time, 621
setup and hold trigger slope, 617
setup configuration, 120, 124, 567
setup defaults, 121, 556
setup memory, 120
setup reported, 586
setup time, setup and hold trigger, 621
setup, recall, 438
setup, save, 453
shape of modulation signal, waveform
generator, 685
SHOLd trigger commands, 616
short form, 5, 800
show channel labels, 236
show measurements, 350, 379
SICL example in C, 913
SICL example in Visual Basic, 922
SICL examples, 913
sigma, mask test run, 423
signal type, 216
signed data, 638
simple command headers, 801
sine waveform demo signal, 224
sine waveform generator output, 673
single acquisition, 161
single frequency, frequency response
analysis, 277
single-ended probe heads, 213
single-ended signal type, 216
single-shot demo signal, 224
single-shot DUT, synchronizing with, 792
skew, 215, 717
skew reference waveform, 707
slope, 510, 601
slope (direction) of waveform, 739
slope not valid in TV trigger mode, 601
slope parameter for delay
measurement, 359
slope, setup and hold trigger, 617
slope, transition trigger, 624
slot, network printer, 321
smoothing acquisition type, 637
snapshot all measurement, 352
softkey menu timeout, 238
software version, 116
source, 380, 476, 498
source for function, 308, 309, 724
source for trigger, 602
source for TV trigger, 631
source input for FFT function, 267
source, automask, 406
source, mask test, 431
source, save reference waveform, 459
source, transition trigger,
625
source, waveform, 654
span, 291, 303
span of frequency on display, 268, 295
specify measurement, 380
SPI, 510
SPI clock timeout, 511
SPI decode bit order, 509
SPI decode word width, 522
SPI MISO data, 658
SPI trigger, 512, 518, 520
SPI trigger clock, 513
SPI trigger commands, 507
SPI trigger frame, 514
SPI trigger MISO data pattern, 517
SPI trigger MOSI data pattern, 519
SPI trigger type, 521
SPI trigger, MISO data source, 515
SPI trigger, MOSI data source, 516
SPI triggering, 462
square wave duty cycle, waveform
generator, 678
square waveform generator output, 673
SRE (Service Request Enable
Register), 126, 772
SRQ (Service Request interrupt), 144, 148
standard deviation measured on
waveform, 378
Standard Event Status Enable Register
(ESE), 112, 777
Standard Event Status Register (ESR), 114,
776
standard for video, 632
standard, LIN, 499
start acquisition, 129, 143, 159, 161
start and stop edges, 357
start cursor, 737
start measurement, 350

Keysight Technologies InfiniiVision DSOX1204A Specifications

General

Brand	Keysight Technologies
Model	InfiniiVision DSOX1204A
Category	Test Equipment
Language	English