8-18
Version 1.73 Copyright © 1997 Link Communications Inc. 1/18/97
Macro 291 is an autopatch macro that is used for number readback mode 2.
Macro Definition
291 Internal Autopatch Macro
Macro 292 is used to speak "Autopatch Off" when you hang up the patch. It is automatically
programmed when you set up the autopatch with Command 110. You can delete it and
program your own autopatch off message if you wish.
Macro Definition
292 Called when the Autopatch is hung-up.
Macro 293 is called when the DTMF cover tone is requested. It normally sends a 440 Hz tone
using command 040. It can be set back to the default beep by entering: "053 293 020 030
0440". Any other tone, cw character, or voice message could also be used, although you will
want to keep the length fairly short.
Macro Definition
293 DTMF cover tone macro
Macro 294 is called when a user logs on using his password. First his callsign is spoken, then
this macro is called. It is normally programmed to speak "control up". It can be programmed
to speak other messages if you wish.
Macro Definition
294 User Logon Message
Macro 295 is called a user tries to log on but gets the password wrong. It normally says "fail".
Macro Definition
295 User Logon Fail Message
To Next Page
Loading...
Need help?
General
