Link Communications RLC-CLUB - Page 15

Version 1.73 Copyright © 1997 Link Communications Inc. 1/18/97
110: Configure the Autopatch ...............................................13-5
111: Manual Off Hook .....................................................13-7
112: Normal Forward Dial ..................................................13-7
113: Forward Dial with no Long Distance Checking ..............................13-8
114: Hang up the Autopatch .................................................13-9
115: Possibly Hang up the Autopatch .........................................13-9
116: Set / Recall the Predial Digits and Timing .................................13-10
117..118: Not Currently Used ...............................................17-8
119: Set Allowed Numbers Table Slot ........................................13-11
120: Recall Allowed Numbers Table Slot .....................................13-11
121: Set Nuisance Numbers Table Slot .......................................13-12
122: Recall Nuisance Numbers Table Slot ....................................13-12
123: Test Dialing Tables ..................................................13-13
124: Set Autodial Slot ....................................................13-14
125: Recall Autodial Slot ..................................................13-14
126: Send Predial Digits / Callsign for Autodial Slot? ............................13-15
127: Enable/Disable an Autodial Slot ........................................13-15
128: Set Full or Half-Duplex Patch Audio for a TX .............................13-16
129: Recall Full or Half-Duplex Patch Audio for a TX ...........................13-16
130: Block Command Execution From Port ....................................5-10
131: Allow Command Execution From Port ....................................5-10
132: Recall Blocked Ports ..................................................5-10
133: Set up Reverse Patch .................................................13-17
134: Access Reverse Patch Control Mode .....................................13-18
135: Answer Reverse Patch ................................................13-18
136: Set up Reverse Autopatch Ring .........................................13-19
137: Autodial Only .......................................................13-19
138: Direct SPI Send using Output Lines .......................................7-7
139: Setup RLC-Icom Interface ..............................................14-8
140: Not Currently Used ....................................................17-8
141: Set Band Unit for RBI-1 or RLC-ICM ....................................14-12
142: Set Frequency (and Offset) for RBI-1 or RLC-ICM .........................14-13
143: Set Offset for RBI-1 or RLC-ICM .......................................14-14
144: Set Offset Format for RBI-1 or RLC-ICM .................................14-15
145: Set Power Level for RBI-1 .............................................14-16
146: Set PL Frequency for RBI-1 or RLC-ICM .................................14-17
147: Turn PL Encode Off/On for RBI-1 or RLC-ICM ............................14-18
148: Turn PL Decode Off/On for RBI-1 or RLC-ICM ...........................14-18
149: Recall Band, Frequency and Offset for RBI-1 or RLC-ICM ...................14-19
150: Recall All RBI-1 or RLC-ICM Settings ...................................14-19
151: Turn Radio Power On or Off for RBI-1 ...................................14-20
152: Goto Radio Memory for RBI-1 .........................................14-21
153..154: Not Currently Used ...............................................17-8
155: Enable or Disable PTT for a Port .........................................2-11
156: Recall Which PTT are Enabled ..........................................2-11
157: Set Up Event Trigger ..................................................20-2
158: Recall Event Trigger Setting ............................................20-2
159: Enable/Disable Event Trigger ...........................................20-2
160: Clear Analog High/Lows ..............................................12-20