14-6
Version 1.73 Copyright © 1997 Link Communications Inc. 1/18/97
Setup and Adjustment
The RBI-1 COR signal is active high. The RLC-ICM COR signal is active low. Set the
COR polarity to active high with command 013.
Audio receive level from the Kenwood to the Controller is controlled by VR2 (R). The audio
level from the Controller to the Kenwood is adjusted by VR1 (T). Refer to your manuals for
additional adjustments in your controller.
Capacitor C5 (10uF) Inside the RBI-1 Interface must be removed and replaced with a 1uF/25V
Tantalum Capacitor for the Audio to sound correct. Remove capacitors C16 and C17 to keep
the audio from sounding too 'Bassy'.
To Next Page
Loading...
Need help?
General
