4-11
Version 1.73 Copyright © 1997 Link Communications Inc. 1/18/97
DVR Record Length Limit Timer:
This timer sets the maximum length of message that can be recorded using the DVR. If you try
to record a longer message, it will be truncated at this length. Of course, if you unkey, press a
DTMF digit or the DVR runs out of memory before this time is up, it will quit recording
sooner. You can set this timer to be relatively long while setting up the DVR, then shorter to
keep people from leaving very long voice mail messages for people.
- This timer is programmed in 1 second increments from 001-9999
- This timer defaults to 030
Timer Number Description Defaults
056 DVR Record Length Limit 30 sec. (030)
User Log-out Timer:
This timer specifies the amount of time between correctly executed command entries that a user
has before the controller logs the user off the system.
Timer Number Description Defaults
057 Log-on timer for Port 1 60 sec. (060)
058 Log-on timer for Port 2 "
059 Log-on timer for the Autopatch "
060 Log-on timer for the Serial Port "
User Log-out Timer:
This timer specifies the amount of time between correctly executed command entries that a user
has before the controller logs the user off the system.
Timer Number Description Defaults
057 Log-on timer for Port 1 60 sec. (060)
058 Log-on timer for Port 2 "
059 Log-on timer for the Autopatch "
060 Log-on timer for the Serial Port "
To Next Page
Loading...
Need help?
General
