4-12
Version 1.73 Copyright © 1997 Link Communications Inc. 1/18/97
Internal DVR Record Window:
This timer specifies the amount of time you have between entering a command to record a
message on the internal DVR and when you have to key up and actually begin recording the
message. If you wait longer than this, the controller will clear the record command and you
will have to enter it again.
Timer Number Description Defaults
061 Internal DVR Record Window RX 1 10 sec. (010)
062 Internal DVR Record Window RX 2 "
063 Internal DVR Record Window Autopatch "
Beacon Timer:
This timer specifies the amount of time the controller will wait before trying to send the next
beacon. See Chapter 19 for more information about the beaconing system.
Timer Number Description Defaults
064 Beacon Timer 1 sec. (001)
Tail Message Timers:
These timers determine the minimum time between tail messages being sent. If they are set to
000, a tail message will be sent every time the transmitter drops. Otherwise, a tail message will
be sent before a transmitter drop only if it has been longer than the timer length since the last
drop out message was sent. In no case will the tail message cause the transmitter to key up;
they will only be sent if something else brings up the transmitter. For more information about
tail messages, see the event triggers table associated with command 157.
Timer Number Description Defaults
065 Tail Message Timer TX 1 5 minutes (300)
066 Tail Message Timer TX 2 "
067 Tail Message Timer Autopatch "
To Next Page
Loading...
Need help?
General
