Link Communications RLC-CLUB - Page 7

Version 1.73 Copyright © 1997 Link Communications Inc. 1/18/97
179: Record Private Mail .............................................6-26
180: Retrieve Private Mail ............................................6-26
181: Erase Private Mail ..............................................6-27
182: Enable/Disable RLC-DVR1 .......................................6-27
The Internal Digital Voice Recorder .....................................6-28
183: Record a Message on the Internal DVR ..............................6-29
184: Playback an Internal DVR Message(s) ...............................6-30
185: Erase Internal DVR Message(s) ....................................6-30
052: Audio Test using the Internal DVR .................................6-31
034: Adjust each Port's Internal DVR Record Level ........................6-32
Chapter 7: Serial Port Commands ...........................................7-1
024: Set Up RS-232 Serial Baud Rate .....................................7-3
060: Set Up Serial Port Options .........................................7-4
032: Send Serial Message out the Main Serial Port ...........................7-5
162: Always Send Serial Message out the Main Serial Port ....................7-5
169: Always Send Serial out Main Serial Port by ASCII Code .................7-6
138: Direct SPI Send using Output Lines ..................................7-7
Chapter 8: Macros ........................................................8-1
How Macros Get Executed: .............................................8-1
What a macro is: .....................................................8-1
Limits on Macros: ....................................................8-2
200..499: Execute a Macro .............................................8-4
053: Program a Single Command Macro Sequence ..........................8-5
054: Recall Macro Contents ............................................8-6
055: Delete Macro ...................................................8-7
056: Append a Command to a Macro .....................................8-7
057: Copy a Macro ...................................................8-7
058: Delete a Command in a Macro ......................................8-8
059: Insert a Command in a Macro ......................................8-8
Automatic Macros ....................................................8-9
Chapter 9: Pre-Access Commands ...........................................9-1
What preaccess is: ....................................................9-1
What you need to know: ...............................................9-1
049: Configure a Port's Tone Response when in Preaccess ....................9-2
070: Configure a Repeater for Preaccess ..................................9-3
071: Configure a Link for Preaccess ......................................9-4
072: Disable Preaccess Requirement for a Port .............................9-5
073: Recall Ports with Preaccess Requirement ..............................9-5
074: Allow Access To a Port that Requires Preaccess ........................9-5
075: Set Stop Access Conditions ........................................9-6
076: Recall Stop Access Conditions ......................................9-7
077: Isolate a Port from the Rest of the System .............................9-7