Link Communications RLC-CLUB - Page 8

Version 1.73 Copyright © 1997 Link Communications Inc. 1/18/97
Chapter 10: Scheduler .................................................... 10-1
How the Scheduler Works: ............................................ 10-1
082: Set Up a Scheduler Event ........................................ 10-2
083: Recall a Scheduler Event ......................................... 10-5
084: Enable/Disable a Scheduler Event .................................. 10-6
Chapter 11: The ID System ................................................ 11-1
How the ID's Work: ................................................. 11-1
Polite Voice ID's: ................................................... 11-1
To Program Your Own ID's: ........................................... 11-2
More about Programming ID's: ........................................ 11-2
ID Timing: ........................................................ 11-3
085: Enable/Disable IDing a Port ...................................... 11-4
086: Recall Which Ports have ID's Enabled .............................. 11-4
087: Set Random or Rotating Pending ID's ............................... 11-5
088: Recall Random or Rotating Pending ID Selection ...................... 11-5
Chapter 12: I/O System ................................................... 12-1
About the I/O System: ............................................... 12-1
Logical Output Lines ................................................ 12-1
Analog Input Lines .................................................. 12-1
Inputs Connector Pin-Out ................................. 12-3
090: Read Whether Input Line is High or Low ............................ 12-4
091: Execute Input Line High or Low Macro ............................. 12-4
092: Enable/Disable Input Line Alarm .................................. 12-5
093: Turn Output Line On ............................................ 12-6
094: Turn Output Line Off ............................................ 12-6
095: Recall Whether Output Line is On or Off ............................ 12-7
100: Read Analog Input Line .......................................... 12-8
101: Set Resolution For Analog Input ................................... 12-9
102: Set Conversion Ratio For Analog Input ............................. 12-11
Custom Analog Conversion Ratios: ......................... 12-12
103: Calibrate an Analog Input ....................................... 12-14
104: Set an Analog Alarm ........................................... 12-15
105: Set Analog Alarm Hysteresis ..................................... 12-16
106: Enable/Disable an Analog Alarm ................................. 12-18
107: Recall Analog Lines in Alarm .................................... 12-18
108: Recall Analog Line Configuration ................................. 12-19
160: Clear Analog High/Lows ........................................ 12-20
161: Set Analog Smoothing Factor .................................... 12-21
Chapter 13: Autopatch Routines ............................................ 13-1
Configuring the Autopatch: ........................................... 13-1
Autopatch Up Commands: ............................................ 13-1
Using '*' for the Autopatch Up Command: ................................ 13-1
Hanging Up: ....................................................... 13-1
Connected Ports: .................................................... 13-2
Predial Digits: ...................................................... 13-2