Version 1.73 Copyright © 1997 Link Communications Inc. 1/18/97
The Autodialer: .....................................................13-2
Limiting Call Length: ................................................13-3
How the Dialing Tables Work: .........................................13-3
Other Commands that Affect the Autopatch: ..............................13-4
110: Configure the Autopatch .........................................13-5
111: Manual Off Hook ...............................................13-7
112: Normal Forward Dial ............................................13-7
113: Forward Dial with no Long Distance Checking ........................13-8
114: Hang up the Autopatch ...........................................13-9
115: Possibly Hang up the Autopatch ....................................13-9
116: Set / Recall the Predial Digits and Timing ...........................13-10
119: Set Allowed Numbers Table Slot ..................................13-11
120: Recall Allowed Numbers Table Slot ...............................13-11
121: Set Nuisance Numbers Table Slot .................................13-12
122: Recall Nuisance Numbers Table Slot ...............................13-12
123: Test Dialing Tables ............................................13-13
124: Set Autodial Slot ..............................................13-14
125: Recall Autodial Slot ............................................13-14
126: Send Predial Digits / Callsign for Autodial Slot? ......................13-15
127: Enable/Disable an Autodial Slot ...................................13-15
128: Set Full or Half-Duplex Patch Audio for a TX ........................13-16
129: Recall Full or Half-Duplex Patch Audio for a TX .....................13-16
133: Set up Reverse Patch ...........................................13-17
134: Access Reverse Patch Control Mode ...............................13-18
135: Answer Reverse Patch ..........................................13-18
136: Set up Reverse Autopatch Ring ...................................13-19
137: Autodial Only .................................................13-19
Chapter 14: Doug Hall RBI-1 and RLC-ICM Routines .........................14-1
What the RBI-1 is: ...................................................14-1
What the RLC-ICM is: ...............................................14-1
Interfacing and Setup: ................................................14-1
Using the RBI-1 or RLC-ICM: .........................................14-2
Building the RBI-1/RLC-ICM Cable .........................14-5
139: Set Up the RLC-Icom Interface ....................................14-8
RLC-ICM Internal Operation Test Points ................................14-11
141: Set Band Unit for RBI-1 or RLC-ICM ..............................14-12
142: Set Frequency (and Offset) for RBI-1 or RLC-ICM ....................14-13
143: Set Offset for RBI-1 or RLC-ICM .................................14-14
144: Set Offset Format for RBI-1 or RLC-ICM ...........................14-15
145: Set Power Level for RBI-1 .......................................14-16
146: Set PL Frequency for RBI-1 or RLC-ICM ...........................14-17
147: Turn PL Encode Off/On for RBI-1 or RLC-ICM ......................14-18
148: Turn PL Decode Off/On for RBI-1 or RLC-ICM ......................14-18
149: Recall Band, Frequency& Offset for RBI-1 or RLC-ICM ...............14-19
150: Recall All RBI-1 or RLC-ICM Settings .............................14-19
151: Turn Radio Power On or Off for RBI-1 .............................14-20
152: Goto Radio Memory Channel for the RBI-1 .........................14-21
To Next Page
Loading...
Need help?
General
