Driving mode
5.6 Heating and air-conditioning system
Operating manual 3 302 819 en 5 - 77
GMK3060
13.12.2018
H
Always switch the auxiliary heater off if you switch off the truck crane while the
battery master switch is switched on. In this way, you prevent the auxiliary heater
from restarting and the batteries from running down after the engine has cooled
down.
Setting the date
and time
The error code TEB is shown in the display if the power supply has been
interrupted for more than 8 minutes. You must reset the date and time.
Always set the current time and current day of the week. These settings are
required for the correct activation point of the automatic heating start.
• Select and confirm the symbol Settings (1) – display symbol Immediate start (2).
• Select and confirm the symbol Day of the week (1) – display symbol (2),
e.g. MON for Monday.
• Select and confirm the desired day of the week.
• Select and confirm the symbol Settings (1) – display symbol Immediate start (2).
• Select and confirm the symbol Time Time (1) – display symbol Time format.
• Select and confirm the desired time format (2) or (3).
The Time display flashes.
• At the flashing display, set the hours and confirm the selection.
s
To Next Page
Loading...
Need help?
General
