Rigging work
12.8 Other rigging work
12 - 108 3 302 819 en Operating manual
GMK3060
13.12.2018
Removing
– Only the camera
• Withdraw the plug (4) from the socket (3) and
close it with the cap.
• Remove the camera (2) from the clamp (1)
and put the retaining pin in the holder (1).
• Wind the cable (5) on to the clamp.
– The camera and the connecting cable
• Withdraw the plug (3) from the socket (4) and
close it with the cap.
• Remove the camera (2) from the clamp (1)
and put the retaining pin in the holder (1).
• Wind the cable (5) on to the clamp.
To Next Page
Loading...
