ï¿ï¿ï¿ï¿ï¿ï¿ï¿ï¿ï¿ï¿ï¿ï¿ï¿ï¿ï¿ï¿ï¿ï¿ï¿ï¿ï¿ï¿
15 Methods
917 Coulometer
ï¿ï¿ï¿ï¿ï¿ï¿ï¿ï¿
129
ï¿ Tap on [Save].
The method will be saved and the command sequence is displayed.
Entering a new name:
ï¿ Tap on the input field File name.
The text editor opens.
ï¿ Enter a new file name (max. 32 characters) and confirm with
[OK].
ï¿ Tap on [Save].
The method will be saved and the command sequence is displayed.
15.3 Loading a method
Proceed as follows to load a method:
1
Opening the method table
ï¿ In the main dialog, tap on [Load method].
The selection of memory locations is displayed. This selection will
be skipped if only the internal memory is accessible.
ï¿ Select the memory location where the desired method is saved.
The selection of file groups is displayed (see chapter 11.1, page
86). If only one group is available, then the method table will be
displayed directly.
ï¿ Select the group with the desired method.
ï¿ Tap on [Show files].
The method table with the stored methods opens:
2
Selecting the method
ï¿ Select the desired method.
To Next Page
Loading...
Need help?
General
