ï¿ï¿ï¿ï¿ï¿ï¿ï¿ï¿ï¿ï¿ï¿ï¿ï¿ï¿ï¿ï¿ï¿ï¿ï¿ï¿ï¿ï¿
19 Sample data
917 Coulometer
ï¿ï¿ï¿ï¿ï¿ï¿ï¿ï¿
153
19 Sample data
You can enter the sample data (identification, sample size, etc.) in a variety
of ways:
ï¿ Directly in the main dialog.
ï¿ Using the sample table. This is particularly useful with sample series.
The sample table is a table in which the sample data for up to 999
samples can be entered (see chapter 20, page 156).
ï¿ Automatic request immediately after the start of the determination (see
chapter 19.2, page 154).
You can also send the sample size and the unit from a connected balance
in any case. With some balances, the sample identification and method
can be also sent (see chapter 31.4, page 296).
19.1 Entering sample data in the main dialog
For a sample, you can enter the sample data directly in the main dialog,
even while the determination is running (see chapter 22, page 167).
Identification 1
Sample identification. The sample identification can be used in calculations
as the variable CI1. If you have defined a sample identification list (see
chapter 14.1.1, page 113) then the entries can be selected here.
Entry 24 characters maximum
Default value empty
To Next Page
Loading...
Need help?
General
