10.7 USB/RS-232 adapter
ï¿ï¿ï¿ï¿ï¿ï¿ï¿ï¿ï¿ï¿ï¿ï¿ï¿ï¿ï¿ï¿ï¿ï¿ï¿ï¿ï¿ï¿
80
ï¿ï¿ï¿ï¿ï¿ï¿ï¿ï¿
917 Coulometer
The following table indicates the balance type that needs to be selected
for the balance model:
Balance Balance type
AND AND
Mettler AB, AE, AG, AM,
AJ, PE, PM, PJ, PR, XP, XS
Mettler
Mettler AT Mettler AT
Mettler AX, MX, UMX, PG,
AB-S, PB-S
Mettler AX
Ohaus Voyager, Explorer,
Analytical Plus
Ohaus
Precisa Precisa
Sartorius Sartorius
Shimadzu BX, BW Shimadzu
10.7 USB/RS-232 adapter
List of devices: USB/RS-232 adapter â–¶ Edit â–¶ COM interface â–¶ Edit
As a rule, balances are equipped with a serial RS-232 interface. To connect
a balance, you will require the 6.2148.050 cable. You can adjust the inter-
face parameters in the dialog Edit device / Port parameters. These set-
tings must match the settings on the connected device.
NOTICE
If you make changes to parameter settings in this dialog, then you must
switch the Coulometer off and back on in order for the changes to take
effect.
To Next Page
Loading...
Need help?
General
