Metrohm 917 - Reports (REPORT)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
28 Parameter
917 Coulometer
￭￭￭￭￭￭￭￭
261
Variable Description
RMC Correlation coefficient for RM
Results, statistics
R# Result (# = 1 - 9)
SMN# Mean value of result R# (# = 1 - 9)
SSA# Absolute standard deviation of SMN# (# = 1 - 9)
SSR# Relative standard deviation of SMN# in % (# = 1 - 9)
SNR# Number of results from which the mean value SMN# was calculated (# = 1 - 9)
SSD Number of determinations that are carried out for the statistics calculations
SNT Statistics status (statistics activated = 1, statistics deactivated = 0)
Common variables
CV# Common variable (# = 1 - 25)
System variables
%RN Sample number, i.e. number that is increased by one at each start of a determination
%SC Start counter, see dialog More determination data / Properties
%AS Autostart status (autostart activated = 1, autostart deactivated = 0)
%AC Autostart counter, i.e. number of autostarts already carried out
%AD Autostart setpoint counter, i.e. number of autostarts to be carried out
%SS Status of the sample table (sample table activated = 1, sample table deactivated = 0)
%SL Number of the current sample table line
%SE Last sample in the sample table processed (yes = 1, no = 0)
28.6 Reports (REPORT)
The reports to be printed out are defined with the command REPORT. A
maximum of ten reports can be defined for each command. The following
reports can be inserted, among others:
￭ Result report
￭ Calculation report
￭ Parameter report
￭ System reports (system settings, sensor list, GLP data etc.)
￭ Method reports (method run, method parameters etc.)