Metrohm 917 User Manual

4.6 Connecting USB devices
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
24
￭￭￭￭￭￭￭￭
917 Coulometer
You will find precise information concerning the pin assignment of the
interface on the Remote Box in the appendix.
4.6 Connecting USB devices
4.6.1 General
The 917 Coulometer has a USB connector (Type A socket) for peripheral
devices with USB interface. If you wish to connect more than one device
to the USB, you can use a commercially available USB hub.
NOTICE
We recommend that the Coulometer be switched off while you set up
or disconnect connections between the devices.
4.6.2 Connecting a USB hub
Use a USB hub with its own power supply.
Connect the USB hub as follows:
1
With the help of the 6.2151.030 cable (length 0.6 m) or the
6.2151.020 cable (length 1.8 m), connect the USB connector of the
Coulometer (Type A) with the USB connector of the hub (Type B, see
manual for the USB hub).
The USB hub is recognized automatically.
4.6.3 Connecting a printer
Printers that are connected to the 917 Coulometer must meet the follow-
ing requirements:
￭ Printer languages: HP-PCL, HP-PCL-GUI, Canon BJL Commands or
Epson ESC P/2
￭ Paper size: A4 or Letter.
Connect the printer as follows:
1
With the aid of the 6.2151.020 cable, connect the USB connector of
the Coulometer (type A) with the USB connector of the printer (type
B, see manual for the printer).
2
Configure the printer in the device manager of the Coulometer (see
chapter 10.5, page 74).

Metrohm 917 Specifications

General

Brand	Metrohm
Model	917
Category	Laboratory Equipment
Language	English