ï¿ï¿ï¿ï¿ï¿ï¿ï¿ï¿ï¿ï¿ï¿ï¿ï¿ï¿ï¿ï¿ï¿ï¿ï¿ï¿ï¿ï¿
10 Device manager
917 Coulometer
ï¿ï¿ï¿ï¿ï¿ï¿ï¿ï¿
79
10.6 Balance
List of devices: Balance â–¶ Edit
You define the type of balance and its connector in the dialog Device
manager / Edit.
Device name
Here you can enter a device name of your choice.
Entry 24 characters maximum
Comment
Entry 24 characters maximum
Balance type
If you have connected a balance, then you have to specify the balance
type here.
Selection AND | Mettler | Mettler AT | Mettler AX |
Ohaus | Precisa | Sartorius | Shimadzu
Default value Sartorius
RS-232
RS-232 interface to which the balance is connected. The interface param-
eters are adjusted in the Edit device / Port parameters dialog (see
chapter 10.7, page 80).
Selection COM 1 | COM 2
Default value COM 1
COM 2
The interface is disabled.
To Next Page
Loading...
Need help?
General
