EasyManuals Logo

Metrohm 917 User Manual

Metrohm 917
338 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #168 background imageLoading...
Page #168 background image
19.2 Requesting sample data at the start of the determination
ï¿­ï¿­ï¿­ï¿­ï¿­ï¿­ï¿­ï¿­ï¿­ï¿­ï¿­ï¿­ï¿­ï¿­ï¿­ï¿­ï¿­ï¿­ï¿­ï¿­ï¿­ï¿­
154
ï¿­ï¿­ï¿­ï¿­ï¿­ï¿­ï¿­ï¿­
917 Coulometer
Identification 2
Sample identification. The sample identification can be used in calculations
as the variable CI2. If you have defined a sample identification list (see
chapter 14.1.1, page 113) then the entries can be selected here.
Entry 24 characters maximum
Default value empty
Sample size
Sample size. The value of the sample size can be used in calculations as
the variable C00.
Input range –99999999 - 9999999999
Default value 1.0
Unit of sample size.
Entry 6 characters maximum
Selection g | mg | µg | mL | µL | pieces
Default value g
Unit defined in method:
The unit defined in the method is ignored. The unit entered in the sample
table is used.
Balance connected and configured:
Value from the connected balance.
Fixed sample size defined in method:
The value will be entered in the corresponding line when the method is
loaded. The existing entry will be overwritten.
19.2 Requesting sample data at the start of the determi-
nation
The sample data can be automatically requested immediately after the
start of the determination in order to ensure that the sample data entry is
not forgotten. This automatic inquiry is requisite for reweighing.

Table of Contents

Other manuals for Metrohm 917

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Metrohm 917 and is the answer not in the manual?

Metrohm 917 Specifications

General IconGeneral
BrandMetrohm
Model917
CategoryLaboratory Equipment
LanguageEnglish

Related product manuals