Metrohm 917 - Adding a New Device; Configuring the Instrument

10.1 Adding a new device
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
64
￭￭￭￭￭￭￭￭
917 Coulometer
10.1 Adding a new device
Of the following device types, you can enter one device each in the device
list, even if it is not yet connected:
￭ Balance
￭ Barcode reader
￭ USB/RS-232 adapter
￭ PC keyboard
Proceed as follows:
1
Displaying the device selection
Tap on [New].
2
Selecting the instrument
Tap on the button for the desired device.
The new device is entered in the list.
10.2 Configuring the instrument
Instrument list: Instrument ▶ Edit
The data stored for an instrument depends on the type of instrument. You
can define an instrument name and a comment for each instrument. The
instrument name of the Coulometer is printed out in the standard report
header.
The description of the individual instruments can be found in the follow-
ing specific chapters:
￭ Coulometer (see chapter 10.3, page 65)
￭ Metrohm control instruments (see chapter 10.4, page 71)
￭ Printer (see chapter 10.5, page 74)
￭ Balance (see chapter 10.6, page 79)
￭ PC keyboard (see chapter 10.8, page 82)
￭ USB/RS-232 adapter (see chapter 10.7, page 80)
￭ Barcode reader (see chapter 10.9, page 84)