28.7 Dosing and Liquid Handling
ï¿ï¿ï¿ï¿ï¿ï¿ï¿ï¿ï¿ï¿ï¿ï¿ï¿ï¿ï¿ï¿ï¿ï¿ï¿ï¿ï¿ï¿
266
ï¿ï¿ï¿ï¿ï¿ï¿ï¿ï¿
917 Coulometer
Report Contents
Common variables
Common variable list List of all the common variables defined in the system, together with
their most important data (name, value, status).
All common variable properties Properties of all common variables (name, value, validity, status).
Templates
Templates sample data Sample identification list and sample assignment table.
Result template list List with all of the user-generated result templates.
All result templates details Details of the all of the user-generated result templates (calculation for-
mula, result options, note).
Input/Output lines List with all of the defined input and output lines at the remote interface
(name, bit pattern).
Custom calibration buffers Temperature tables for all defined custom calibration buffers.
Rack tables
Sample rack list List with all of the sample racks configured in the system, together with
designation, number of positions and rack code.
Miscellaneous
Form feed If this entry is inserted between two reports, then these will each be
printed out on a separate page.
28.7 Dosing and Liquid Handling
The following dosing commands are available:
Preparing the
exchange unit or
dosing unit (PREP)
Rinsing the cylinder and the tubings of the
exchange unit / dosing unit.
Emptying the dos-
ing unit (EMPTY)
Emptying the cylinder and the tubings of the
dosing unit.
Dosing a fixed vol-
ume (ADD)
Dosing a specified volume.
Liquid Handling
(LQH)
Carrying out complex dosing tasks with a Dos-
ino.
28.7.1 Preparing an exchange or dosing unit (PREP)
The PREP command is used to rinse and fill air bubble-free the cylinder
and tubings of the exchange or dosing unit. You should carry out this
function before the first determination or once a day.
Control device
Selection Selection of configured control devices
To Next Page
Loading...
Need help?
General
