ï¿ï¿ï¿ï¿ï¿ï¿ï¿ï¿ï¿ï¿ï¿ï¿ï¿ï¿ï¿ï¿ï¿ï¿ï¿ï¿ï¿ï¿
14 Templates
917 Coulometer
ï¿ï¿ï¿ï¿ï¿ï¿ï¿ï¿
125
14.5 Report header
Main dialog: System â–¶ Templates â–¶ Report header
In the dialog Templates / Report header, you can create a system-spe-
cific report header that contains information concerning the laboratory,
for example. The report header can contain a maximum of four lines of 46
characters each and will always be printed out in front of the standard
report header. The standard report header contains the instrument type,
serial number and program version of the software, instrument name and
printing date.
Print logo
on | off (Default value: off)
If this parameter is activated, then the logo defined below will be printed
out in the right margin.
Logo
Selection Metrohm logo | Custom logo
Default value Metrohm logo
Custom logo
Select this setting if your logo is to be printed out in the report header.
How to create a logo is described below.
Applying the custom logo
You can create a graphics file of your own and use it as a logo in the
report header in place of the Metrohm logo.
NOTICE
Observe the size of the graphics object. The maximum size of your
graphics file is 64 kB. We recommend a maximum of 500 × 200 pixels.
Proceed as follows to create your own logo:
1
Creating the logo
ï¿ Create a graphics file with the desired logo in an image process-
ing program.
ï¿ Save the graph as a JPG file under the file name
"CustomImage.jpg".
To Next Page
Loading...
Need help?
General
