￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
25 Result table
917 Coulometer
￭￭￭￭￭￭￭￭
197
Result
In the input fields Value from … to, specify the value range according
to which filtering is to be carried out.
Method
In the field is equal to, select or enter the method name according to
which filtering is to be carried out.
Sample size
In the input fields Value from … to, specify the value range according
to which filtering is to be carried out.
User
In the field is equal to, select or enter the user according to whom
filtering is to be carried out.
NOTICE
The filter can be applied to empty fields as well, for example, if no sam-
ple identification has been entered. In this case, select only the desired
filter criterion and leave the fields below empty.
Deleting the result table automatically
Result table: Properties ▶ Delete automat.
In the Properties / Delete automatically dialog, you define when the
contents of the result table is to be automatically deleted.
Delete oldest line only
on | off (Default value: off)
If this option is activated at the same time that the result table is full, the
oldest entry will be deleted as soon as the results of a new determination
are saved.
Time when result table is deleted:
Switch on
on | off (Default value: off)
If this option is activated, then the result table will be deleted each time
you switch on the Coulometer.
Start a new sample series
on | off (Default value: off)
If this option is activated, then the result table will be deleted when you
start a new sample series (with activated autostart function!).
To Next Page
Loading...
