Configuring the TM80 Changing the Device Name
TM80 Telemetry Monitor Operator’s Manual 12 - 17
ǂ Tap Service Password and follow the on-screen instructions to change the
service password.
2. Tap the icon to exit the Edit Passwords menu.
12.10 Changing the Device Name
1. In the Maintenance menu, tap Device Name.
2. Use the on-screen keyboard to input the device name.
3. Tap Accept to save the setting and exit the Device Name menu.
12.11 Setting CMS Disconnect Alarm
In the Maintenance menu, you can set whether to enable CMS Disconnect Alarm This
option is enabled by default.
ƾ When it is enabled, after the TM80 is disconnected from the CMS:
ǂ The TM80’s display is turned on automatically.
ǂ The TM80 issues a low-pitched beep, its alarm light indicator flashes in cyan,
and the “No Central Monitoring” message is displayed in the prompt mes-
sage area of the TM80.
ƾ When it is disabled, after the TM80 is disconnected from the CMS:
ǂ The TM80’s display is not turned on automatically. But you can turn on the
display manually.
ǂ The TM80 does not issue a low-pitched beep and its alarm light indicator
does not flash. But the “No Central Monitoring” message is still displayed in
the prompt message area of the TM80.
NOTE
• Do not set the same device name for the TM80s.
WARNING
• When CMS Disconnect Alarm is disabled, the medical staff should pay
more attention to the patient’s status and check the TM80’s network
connection status at the CMS. When the offline alarm is displayed on the
CMS, medical staff should check the patient ‘s status immediately.
To Next Page
Loading...
