Configuring the TM80 Configuring the Network Menu
TM80 Telemetry Monitor Operator’s Manual 12 - 7
5. Tap the icon to exit the Quick Keys menu.
12.5.2 Deleting a Quick Key
1. From the quick keys area at the bottom of the Quick Keys menu, press and hold
the desired quick key for two seconds, and then release it.
The quick key background turns to red and displays Delete.
2. Tap Delete.
The quick key is removed from the quick keys area, and the area displays Not
Used.
3. Tap the icon to exit the Quick Keys menu.
12.6 Configuring the Network Menu
The wireless module used in the TM80 is in compliance with IEEE 802.11 a/b/g/n/ac.
In the Network menu, you can configure the network and connect the TM80 to the Ben-
eVision Central Monitoring System via the wireless network.
To configure the Network menu:
1. In the Maintenance menu, tap Network.
2. Select the options described in the following table.
3. Tap the icon to exit the Network menu.
Options Action Description
IP Address Setup Select to access the IP Setting menu. Refer to "Configuring IP Settings"
on page 12 - 8 for details.
WLAN Setup Select to access the WLAN Setting menu. Refer to "Configuring WLAN Set-
tings" on page 12 - 9 for details.
Connect CMS Select to access the Connect CMS menu.
Wireless Setup Select the desired wi-fi band. Refer to "Selecting WiFi Bands
and Channels" on page 12 - 11 for
details.
EAP Certificate Import desired certificates and delete cer-
tificates from the TM80.
Refer to "EAP Certificate Manage-
ment" on page 12 - 12 for details.
To Next Page
Loading...
Need help?
General
