Configuring the TM80 Configuring the Network Menu
TM80 Telemetry Monitor Operator’s Manual 12 - 9
3. Tap Confirm to apply the settings and exit the IP Address Setup menu.
12.6.2 Configuring WLAN Settings
1. In the Network menu, tap WLAN Setup.
2. Select the options described in the following table.
3. Tap Confirm to apply the settings and exit the WLAN Setup menu.
IP Gateway Select to input the IP gateway address. Range: 1 to 255 for the number
before the first decimal point
0 to 255 for the number after the
first decimal point
Factory default: 192.168.0.254
Options Description Settings*
* The factory default settings are in bold.
Options Description Settings*
Network Name Select to input the name for the desired
wireless network.
N/A
Security Type Configure the wireless network security
type.
The options are dependent on the WiFi
Band selected.
If WPA2-PSK is selected, you need to con-
figure Network Password.
If WPA2 EAP or WPA2 CCKM is selected,
you need to configure Network Pass-
word and additional items such as EAP
Method and Authentication.
You also need to import the desired certif-
icate into the TM80 before you can
select a certificate. For how to manage
certificates, refer to "EAP Certificate Man-
agement" on page 12 - 12.
WPA2 PSK, WPA2 EAP, WPA2
CCKM
* The factory default settings are in bold.
To Next Page
Loading...
Need help?
General
