Getting Started Using the Pouch
TM80 Telemetry Monitor Operator’s Manual 3 - 15
3.8.1 Securing the Pouch for the TM80
To secure the pouch:
1. Place the TM80 into the pouch with the ECG leadwires and the SpO
2
sensor cable,
if used, exiting from the pouch opening, as shown in the following figures.
2. Pinch the snap-fastener to close the pouch.
3. Secure the pouch on the patient with ties around the patient’s shoulder and under
the arm, as shown in the following figure.
CAUTION
• If a patient needs to take a shower, check the TM80 as described in "Reg-
ular Check" on page 17 - 3 before showering, use the specified disposable
pouch only, and secure the pouch on the patient as described in this sec-
tion.
• During showering, do not let water enter or accumulate in the pouch.
Besides, do not perform SpO
2
or NIBP measurement.
• When the patient is showering, signal quality and leads off detection
may be compromised due to significant movement. Appropriate clinical
precautions must be taken.
For disposable pouch
To Next Page
Loading...
