Cleaning and Disinfecting Cleaning and Disinfecting the Equipment
TM80 Telemetry Monitor Operator’s Manual 16 - 5
16.3.2 Cleaning the Equipment
Clean your equipment on a regular basis. Before cleaning the equipment, consult your
hospital’s regulations for cleaning the equipment.
Before cleaning the equipment, make the following preparation:
■ Install the battery pack or battery tray and firmly close to seal the battery
compartment.
■ Insert the SpO
2
cover in the SpO
2
connector when SpO
2
is not in use.
■ Insert the ECG leadwire plug into the ECG connector.
NOTE
• For equipment with the symbol , all the listed cleaning and
disinfecting agents are available for use. For equipment without the
symbol , only the cleaning and disinfecting agents marked with “*”
are available for use.
To Next Page
Loading...
Need help?
General
