Cleaning and Disinfecting Cleaning and Disinfecting ECG Leadwires and SpO2 Sensors
TM80 Telemetry Monitor Operator’s Manual 16 - 7
16.3.3 Disinfecting the Equipment
Disinfect the equipment as required in your hospital’s servicing schedule using the
disinfecting agents list in "Approved Cleaning and Disinfecting Agents" on page 16 - 3.
Cleaning before disinfection is recommended.
16.4 Cleaning and Disinfecting ECG Leadwires and SpO
2
Sensors
To clean and disinfect reusable ECG leadwires and SpO
2
sensors, refer to the instructions
for use delivered with the accessory.
CAUTION
• To maximize effectiveness and minimize buildup of residual
disinfectants, please strictly adhere to disinfectant manufacturer’s
instructions for use.
• Wring excess disinfectant from wipe before using.
• Never allow the disinfectants to spill or enter the plug, connector or
battery compartment. If liquid has accidentally entered the equipment
or its parts, shut down the equipment and have the device serviced by
authorized service personnel.
To Next Page
Loading...
Need help?
General
