Powering On the Unit Getting Started
3 - 8 TM80 Telemetry Monitor Operator’s Manual
4. Press down the battery tray until it closes firmly, as indicated by the arrow in the
following figure:
3.5 Powering On the Unit
When the rechargeable lithium-ion pack or AA battery tray is properly installed into the
compartment door, the TM80 will be powered on automatically. The alarm light will
momentarily illuminate cyan to indicate that the equipment is starting. The TM80 per-
forms a self-test during startup. The alarm light flashes red, yellow, and cyan in turn, and
then off. This indicates that the alarm system functions correctly.
When the TM80 installed with the rechargeable lithium-ion pack or AA battery tray is
powered off, press the key to turn it on.
Upon powering up, there are two situations:
â– When the TM80 is turned on for the first time, the device will request you to
configure first time startup. Please make your desired configurations as prompted.
â– When the TM80 is turned on the next time, the device will prompt whether it is a
new patient. Select Ye s or No as desired. If the device is a lock mode, a passcode is
required.
WARNING
• Check that visual and auditory alarm signals are presented correctly
when the equipment is powered on. Do not use the equipment for any
monitoring procedure on a patient if you suspect the equipment is not
working properly or if the equipment is mechanically damaged. Contact
your service personnel or Mindray.
To Next Page
Loading...
Need help?
General
