Configuring the TM80 Configuring the General Menu
TM80 Telemetry Monitor Operator’s Manual 12 - 3
3. Tap the icon to exit the General menu.
12.3.1 Configuring Device Location
You can change device location and set whether to allow modifying a department
name, room number, and bed number in the Patient Info menu.
To configure device location:
1. In the Maintenance menu, tap General.
2. Tap Device Location.
3. Tap Facility.
4. Enter the desired name.
5. Tap Department .
6. Select the desired option.
â—† Fixed: you cannot modify Department in the Patient Info menu. Depart-
ment is the one entered in the Department field of the Device Location
menu.
â—† Unfixed: you can modify Department in the Patient Info menu.
7. Tap Bed No./Room No.
Date &Time Configures the time format, date format,
specific time, and date.
Time Format: 12Hr, 24 Hr
Date Format: DD/MM/YY, YY/MM/
DD, MM/DD/YY
Resp This option is available only when the
Resp functionality is supported.
When it is supported and Resp is enabled,
Resp numeric and waveform are displayed
on the screen.
On, Off
Options Description Settings*
* The factory default settings are in bold.
NOTE
• Mindray recommends the same SpO
2
tone mode be used for the device
within a monitoring area.
To Next Page
Loading...
Need help?
General
