Configuring the Network Menu Configuring the TM80
12 - 12 TM80 Telemetry Monitor Operator’s Manual
◆ When 5G is selected, tap AN Channels.
5. Select the desired channels.
12.6.6 EAP Certificate Management
You can import up to 10 certificates from a USB drive or delete certificates from the
TM80.
The TM80 only supports certificates in PEM format. If you need to use certificates in
other formats, you need to convert the certificates before importing them into the
TM80. The openssl tool (version 1.0.2c or later) is recommended for the conversion, and
you can get the setup file on internet conveniently.
12.6.6.1 Importing Certificates
Up to 10 certificates can be imported from a USB drive. Only authorized personnel can
import certificates.
Required tools:
■ An empty USB drive (FAT data format and at least 256 MB space)
■ One USB upgrade cable (P/N: 009-005409-00)
■ One computer used to prepare USB drive tools
■ One power module with USB port (output voltage: 5 V, output current not less
than 1 A)
Follow this procedure to import certificates:
1. Insert a USB drive to the USB port of your computer
2. Create the folder named “Cert” in the USB drive.
3. Copy the desired certificates to the “Cert” folder.
4. Remove the battery from the battery compartment and find the MicroUSB socket
inside the battery compartment. Connect the MicroUSB end of the USB upgrade
cable to the MicroUSB socket, insert the prepared upgrade USB drive on the USB
female connector of the upgrade cable, and connect the USB male connector of
the upgrade cable to the USB power adapter as shown below.
NOTE
• BGN Channels and AN Channels default to be blank. Channels need to
be selected to improve roaming performance.
To Next Page
Loading...
Need help?
General
