(00292)H 8 - 15
With batch downloads, the data for the range of the frame numbers specified for all of the data
blocks for the camera is downloaded. Blocks cannot be specified.
The frame numbers displayed in the Start Save+End Save when the “Download” dialogue was
opened are the minimum frame number and maximum frame number for the range saved, and
so differ from the start frame and end frame shown on the slider bar.
The camera recorded block and the recorded range immediately after multi trigger recording
is shown in the following example.
・Block 1 (Recorded range: -555 ~ +554)
・Block 2 (Recorded range: -555 ~ +554)
・Block 3 (Recorded range: -555 ~ +554)
・Block 4 (Recorded range: -555 ~ +554)
・Block 5 (Recorded range: -555 ~ +554)
Open the “Download” dialogue, and set the following save range to download.
・Start Save: Frame -2
・End Save: Frame +10
The playback block for the created MCFF and the playback range are shown as follows.
・Block 1 (Playback Range: -2 ~ +10)
・Block 2 (Playback Range: -2 ~ +10)
・Block 3 (Playback Range: -2 ~ +10)
・Block 4 (Playback Range: -2 ~ +10)
・Block 5 (Playback Range: -2 ~ +10)
To Next Page
