(00292)H 4 - 7
Manual and Automatic Camera Configuration Settings
The two methods of executing the GX-5/GX-5F "Camera Configuration Settings" includes
"MANUAL", that executes by operating the HXLink or J-PAD3, and "AUTO" that automatically
performs the "Camera Configuration Settings" after verifying the camera head connected during DRP
startup. Use the “Camera System Settings” (HXUtility) and set the camera configuration mode to
either "MANUAL" or "AUTO". The camera configuration mode for the GX-5/GX-5F is set to
"MANUAL" at factory shipment.
Use the HXUtility to set the camera configuration mode. Refer to page 10-9 for details.
Turn off the power to the DRP when adding or deleting camera heads on the
GX-5/GX-5F. If the DRP is still powered when attaching or removing camera heads,
the DRP and camera head may be damaged. Also, since devices connected to a
malfunctioning device may be damaged, do not use the malfunctioning device and
have it repaired.
Caution If implementing the Camera Configuration Settings, the image data recorded in the
camera memory will be lost. To keep data, be sure to download the image data
before implementing the camera configuration settings.
Caution If using the "AUTO" camera configuration mode, save the data recorded before
turning off the DRP power even if there is a memory backup.
If the camera head cannot be verified during DRP startup due to a camera head
connection problem, the image data will be lost during camera configuration
setting.
To Next Page
Loading...