(00292)H 2 - 5
2.2 Installation Procedures
Have an authorized user of the Windows Administrators group log on.
The following settings can be required prior to installation.
Start the HXLink installation once the settings are complete.
For using Q camera,
Install GenIcam and GigE Vision Filter Driver in accordance with the environment.
Confirm your windows environment prior to HXLink installation.
Open “Control Panel”, “all control panel items”, “System”, check whether 32bit/ 64bit
in ”System type”.
If HXLink and/or GigE Vision Filter Driver are already installed,
please perform the uninstallation. Refer to page 2-21 for details.
For a TCP/IP MEMRECAM connection,
"TCP/IP Network Optimization" is performed when HXLink is installed. Install to a PC
connected to a LAN (Ethernet HUB) or a MEMRECAM that is turned on.
During HXLink installation, if the PC is not connected to a LAN or a MEMRECAM, you will
be required to conduct "TCP/IP Network Optimization" again when the MEMRECAM is
connected. Click on "TCP/IP Network Optimization" in the Windows start menu and reboot the
PC after setting.
For the installation method when connecting the K5, RX-6G, RX-5G camera for the Gbit
(1000BASE-T) connection using Windows XP,
install the the iSCSI Initiator and set the PC network by referencing the supplemental camera
manual "1000BASE-T Interface Connections Supplemental User's Manual (800152)". The
"1000BASE-T Interface Connections Supplemental User's Manual (800152)" refers to the use
of fxLink as the camera control software but with HXLink installed instead of fxLink.
When connecting the K5, RX-6G, RX-5G camera for the Gbit (1000BASE-T) connection using
Windows Vista,
start up the "Microsoft iSCSI Initiator Service" by referencing the procedure on page 2-16.
To Next Page
Loading...