NAC Image Technology SP-642 - Adjust Image Quality Menu

5 - 12 (00292)H
■"Adjust Image Quality" Menu
Items that can be set with the "Adjust Image Quality" menu are described below.
・Gain
This function supports the MEMRECAM Gain function. (*)
Set LOW, NORMAL, HIGH in the MEMRECAM HX, GX, Q.
LOW Lower gain by one aperture.
NORMAL Normal brightness.
HIGH Raise gain by one aperture.
Set 0dB, +6dB, +12dB in the MEMRECAM ci, fx series.
0db Normal brightness.
+6db Raise gain by one aperture.
+12db Raise gain by two apertures.
* The luminance are only enabled with NORMAL.
* The gain cannot be changed for image files recorded when the DRES mode (dynamic range
expansion shutter mode) is selected.
・White Balance
This function supports the MEMRECAM white balance function.
REG The white balance value saved in the MEMRECAM SET REG function while
recording.
3100 3100K setting for lighting color temperature.
5000 5000K setting for lighting color temperature.
9000 9000K setting for lighting color temperature.
CUSTOM CUSTOM white balance setting.
Select CUSTOM for the previously set white balance value.
Select "Change Settings" to display the "White Balance" dialogue and set
the white balance with pointer settings, range specification and numerical
input.
Refer to page 5-18 for details.
AUTO Auto White Balance setting
Select “Select AUTO” for the value calculated in advance for white balance.
Select "Change Settings" for the calculated white balance value for the
frame displayed.
Refer to page 5-20 for details.
・Enhance
This function supports the MEMRECAM Enhance function.
OFF Setting for the image as recorded.
LOW Low enhance setting.
NORMAL Normal enhance setting.
HIGH High enhance setting.