9 - 8 （00292)H
・Sync Settings Synchronizes camera times when M-HUB connected to fx camera.
Used when IRIG connected or if errors made in sync settings during camera
connection.
Refer to page 6-4 for details of camera times.
Refer to page 14-4 for details of sync setting errors.
“Sync Settings” are disabled when on the HX and GX cameras are connected.
・Disconnect Disconnect communication with all cameras.
・Detailed Settings With one camera control, the windows displayed vary according to the
“GUI Settings” tab in the “Options” dialogue.
Refer to page 7-2 for the method of switching the windows shown.
Refer to page 4-28 for the “Camera Details” dialogue.
Opens the “List of Camera Settings” with multiple camera control.
Refer to page 4-14 for details.
・Memory Segment Operation
Partition segments / scan segments / hide segments /
Scan segments in all cameras / hide segments in all cameras
Refer to page 4-58 for details.
・Auto Exposure Control (AEC)
AOI/ image cartridge / image trigger - standard brightness/AE/AE CYCLE
Refer to page 4-45 for details.
・Luminance
NORMAL / LINEAR/ CUSTOM
Input/output properties when image data shown.
Can be used with GX cameras.
Select “NORMAL” to use gain, gamma, knee.
Select “LINEAR” to ignore the gain, gamma, knee settings and convert the
camera data to linear for display.
Select “CUSTOM” to custom set the luminance.
Refer to page 5-14 for custom settings operation.
・Luminance Import TABLE data / Save luminance in TABLE data
Import TABLE data luminance to save.
Refer to page 5-15.
・Video Output of All Cameras
Switch ON/OFF the video output for all of the connected cameras.
・Lock Remote Control
Prohibit camera operation from the J-PAD3.
・Release Remote Control Lock
Allow camera operation from the J-PAD3.
・Release PC Lock
Allow camera operation from the PC. The PC lock is set with “PC LOCK” in the
J-PAD3 menu (SYS MENU) .
To Next Page
Loading...