10-12 (00292)H
Next, update the firmware with the following procedure.
Confirm that the GX cameras with the settings have
started up and the PC and cameras have connected to the
network. Additionally, confirm that the camera is not in
use and the J-PAD3 is connected to the camera.
Startup the HXUtility and click "Update JPAD3
Firmware".
The "Select Camera" dialogue is displayed with a list of
the cameras currently connected to the network. An " ×"
is shown on the camera icon for the cameras in use.
Check a camera to update the J-PAD3 firmware and click
"OK".
A confirmation dialogue appears. Click "Yes" to start
updating the J-PAD3 firmware connected to the camera.
Then do not operate until "Completed Normally" appears.
To Next Page
Loading...