NEC Electra Elite IPK - Automatic Day;Night Mode Switching Time Assignment

Elite IPK Document Revision 1
Programming Manual 2 - 33
___________________________________________________________________________________
___________________________________________________________________________________
1-1-27 Automatic Day/Night Mode Switching
Time Assignment
General Description
Use this Memory Block to assign a start time for Pattern 1 and a different start time for
Pattern 2 to automatically switch between Day Mode and Night Mode.
Display
Programming Procedures
1
Go off-line.
2 Press LK1 +
LK1 +
BG
to access the Memory Block.
3
Enter the data using the dial pad.

Use the following to enter data:
J
to move the cursor left
L
to move the cursor right
K
~
I
to enter numeric data
H
to clear all data when the cursor is in the Data No. position.
Default Values
Not Specified
4 Press
G
to write the data. The switching time for pattern 2 is displayed.
5 Use the dial pad to change the time.
6
Press
G
to write the data and display the next Memory Block.
7 Program the next Memory Block or press
E
to go back on-line.
Related Programming
M.B. Number Memory Block Name
1-1-32
Automatic Day/Night Mode by Day of Week Selection
1-4-05
Automatic Tandem Trunk by Night Mode Selection
1-8-07
Class of Service (Attendant) Feature Selection I
1-8-48
Automatic Daylight Saving Time Selection.
4-07
Code Restriction Class Assignment (Day Mode)
4-08
Code Restriction Class Assignment (Night Mode)
4-09
Telephone to Tenant Assignment
System Mode
1
Submode
1
Data No.
27
PC Programming
¦ +BM
2 7 : 1 : , :
T I M E D I S P L A Y
Day Mode
Start Time
Setting
Data
Night Mode
Start Time
Setting
Data
Data
No.
Pattern
(1/2)