Elite IPK Document Revision 1
Programming Manual 2 - 79
___________________________________________________________________________________
___________________________________________________________________________________
1-1-68 8-Digit Matching Table to OCC Table
Assignment
General Description
Use this Memory Block to assign each 8-Digit Matching Table to each Other Common
Carrier (OCC) Code Table.
Display
Settings
Page 1
Related Programming
Refer to Chapter 3 Advanced Applications, Section 1 Code Restriction on page 3-1.
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8
Default not
assigned.
Table 00 Table 01 Table 02 Table 03 Table 04 Table 05 Table 06 Table 07
Page 2
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8
Table 08 Table 09 Table 10 Table11 Table 12 Table13 Table14 Table15
Programming Procedures
1 Go off-line.
2 Press LK1 +
LK1 +
FH
to access the Memory Block.
3 Press the corresponding CO/PBX line key to change data option.
Use the following to enter data:
C
to access the next page
A
to access the previous page
Each time a CO/PBX line key is pressed, the LED toggles between On
and Off.
Default Values
OCC Tables 01~15:
All Matching Tables Not Used
OCC Table 16:
Matching Tables 00~14 Not Used
Matching Table 15 Used
4 Press
G
to write the data and advance to the next OCC table. Repeat steps 3 and 4 until last OCC data is entered.
5 The next Memory Block is displayed.
6 Program the next Memory Block or press
E
to go back on-line.
System Mode
1
Submode
1
Data No.
68
PC Programming
¦
+AC
Data
No.
6 8 : 8 D G O C C ( 0 1 ) | 1
T I M E D I S P L A Y
OCC
Table
01~16
Title Page No.
CO/PBX Line LED Off On
Data
Unused Used
The shaded area
is the default
setting.
To Next Page
Loading...
