NEC Electra Elite IPK Programing Manual

2 - 130 Memory Blocks
___________________________________________________________________________________
___________________________________________________________________________________
Document Revison 1 Elite IPK
1-4-01 Automated Attendant First Digit PBR
Release Time Selection
General Description
Use this Memory Block to specify the time a Push Button Receiver (PBR) remains
connected after the Automated Attendant message is played when a calling party calls
in through an Automated Attendant trunk.
Display
Settings

Notes

LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8 The shaded
selection is the
default.
5s 10s
20s 30s 40s 50s 60s
Programming Procedures
1 Go off-line.
2 Press LK1 + LK4 +
JA
to access the Memory Block.
3 Press the corresponding CO/PBX line key to change the data option.
4 Press
G
to write the data and display the next Memory Block.
5 Program the next Memory Block or press
E
to go back on-line.
After PBR is connected, dialing must be completed in the specified time. After the first digit is dialed, interdigit
time (default 7 sec.) controls the PBR time. Dialing the third digit exceeds the 20 sec. default, and the PBR is
disconnected.
System Mode
1
Submode
4
Data No.
01
PC Programming
¦ +AU
0 1 : A A P B R T I M E 2 0 s
T I M E D I S P L A Y
Setting
Data
Data
No.
Title

NEC Electra Elite IPK Specifications

General

Brand	NEC
Model	Electra Elite IPK
Category	Telephone
Language	English