Elite IPK Document Revision 1
Programming Manual 2 - 9
___________________________________________________________________________________
___________________________________________________________________________________
1-1-06 CO/PBX Incoming Ringing Alarm
Time Selection
General Description
Use this Memory Block to specify the time between when a CO/PBX call is detected
and the ringing tone changes to a higher pitch when the call is not answered. When
No Limit is selected, the ringing tone does not change.
Display
Settings
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8
The shaded
selection is the
default.
10s 20s 30s
∞
(No Limit)
Programming Procedures
1 Go off-line.
2
Press LK1 +
LK1 +
KF
to access the Memory Block.
3
Press the corresponding CO/PBX line key to change the data option.
4 Press
G
to write the data and display the next Memory Block.
5 Program the next Memory Block or press
E
to go back on-line.
Related Programming
M.B. Number Memory Block Name
1-1-07
Tie Line Delay Ringing Time Selection
3-07
CO/PBX Ringing Variation Selection
4-01
CO/PBX Ring Assignment (Day Mode)
4-02
CO/PBX Ring Assignment (Night Mode)
4-91
Telephone Ringing Variation Selection
System Mode
1
Submode
1
Data No.
06
PC Programming
¦
+BM
0 6 : R I N G A L M
∞
T I M E D I S P L A Y
Setting
Data
Title
Data
No.
To Next Page
Loading...
