Elite IPK Document Revision 1
Programming Manual 2 - 121
___________________________________________________________________________________
___________________________________________________________________________________
1-3-03 First Digit PBR Release Time
Selection
General Description
Use this Memory Block to specify the time a Push Button Receiver (PBR) circuit is
connected when a dual-tone multifrequency (DTMF) Single Line Telephone user goes
off-hook. After the time expires, the PBR is disconnected. When the Single Line
Telephone user dials a digit before the time expires, a PBR interdigit time starts.
Display
Settings
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8 The shaded
selection is the
default.
10s 20s 30s 40s 50s 60s
Programming Procedures
1 Go off-line.
2 Press LK1 +
LK3 +
KC
to access the Memory Block.
3 Press the corresponding CO/PBX line key to change data option.
4 Press
G
to write the data and display the next Memory Block.
5 Program the next Memory Block or press
E
to go back on-line.
Related Programming
M.B. Number Memory Block Name
1-8-10
PBR Interdigit Release Time Selection
4-95
DTMF/DP SLT Type Selection
System Mode
1
Submode
3
Data No.
03
PC Programming
¦
+BTI
0 3 : P B R R L S 1 0 s
T I M E D I S P L A Y
Data
No.
Title
Setting
Data
To Next Page
Loading...
