Programming Manual 1 - 1
___________________________________________________________________________________
___________________________________________________________________________________
Multiline Terminal
Programming
Chapter 1
SECTION 1 GENERAL INFORMATION
A stored program controls the Elite IPK system. When the system is initially powered
up, the CPUI( )-U( ) ETU scans all interface and ISA slots to determine the hardware
configuration. The system stores this information and the default values in the
resident system program memory. After initially powering up the system, a trained
technician can change the resident system program to meet the specific needs of an
individual customer.
SECTION 2 PROGRAMMING THE SYSTEM
System data programming may be necessary when:
H
the system is installed for the first time.
H
components of an existing system are replaced.
H
functions of an existing system are changed.
The battery on the CPU must be connected. When the battery is not
connected before programming begins, data may be lost when a
power outage occurs.
To Next Page
Loading...
