NEC Electra Elite IPK - IP Phone Block Assignment

2 - 116 Memory Blocks
___________________________________________________________________________________
___________________________________________________________________________________
Document Revison 1 Electra Elite IPK
1-2-32 IP Phone Block Assignment
General Description
Use this Memory Block to specify the number of IP Phones that can be used with the
IPCA( )-U( ) ETU (CPU board)
Display
Settings
Page 1 Po
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8
Default: No PS
Telephone
Blocks are
assigned.
Port 01~04 Port 05~08 Port 09~12 Port 13~16 Port 17~20 Port 21~24 Port 25~28 Port 29~32
Page 2 Ports 33~64
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8
Port 33~36 Port 37~40 Port 41~44 Port 45~48 Port 49~52 Port 53~56 Port 57~60 Port 61~64
Page 3 Ports 65~96
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8
Port 65~68 Port 69~72 Port 73~76 Port 77~80 Port 81~84 Port 85~88 Port 89~92 Port 93~96
Page 4 Ports 97~C0
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8
Port 97~A0 Port A1~A4 Port A5~A8 Port A9~B2 Port B3~B6 Port B7~C0
LED Status Off On (Green) On (Red)
Default is shaded, and no IP
Phone Blocks are Assigned
Data Not Assigned IP Assigned)
Block Not
Available
Programming Procedures
1 Go off-line.
2 Press LK1 + LK2 + 32 to access the Memory Block.
3 Press the corresponding CO/PBX line key to change the Data option.

LK Off – Not Assigned

LK Green – Block Assigned for IP Phone

LK Red – Block not available for IP Phone
4 Press
C
to go to the next page.
Press
A
to return to the previous page.
System Mode
1
Submode
2
Data No.
32
PC Programming
¦ +AH
3 2 : I P A S S I G N | 0 1
T I M E D I S P L A Y
Setting Data
Data 00~CO
Title
Data
No.